{"@type": "dcat:Dataset", "DOI": "10.21947/1483855", "accessLevel": "public", "bureauCode": ["019:20"], "contactPoint": {"@type": "vcard:Contact", "fn": "Lee Fingersh", "hasEmail": "mailto:lee.fingersh@nrel.gov"}, "dataQuality": true, "description": "**Overview**\n\nSequence V: Tip Plate (F)\n\nThis test sequence used an upwind, rigid turbine with a 0\u00b0 cone angle. The wind speed ranged\nfrom 5 m/s to 25 m/s, and the yaw angle was held at 0\u00b0. The blade pitch angle was 3\u00b0. The rotor\nrotated at 72 RPM. Blade pressure measurements were collected. The five-hole probes were\nremoved and the plugs were installed. Plastic tape 0.03-mm-thick was used to smooth the\ninterface between the plugs and the blade. The teeter dampers were replaced with rigid links, and\nthese two channels were flagged as not applicable by setting the measured values in the data file\nto \u201399999.99 Nm. The teeter link load cell was pre-tensioned to 40,000 N. During post-processing,\nthe probe channels were set to read -99999.99. The standard tip blocks were replaced\nwith a tip plate to simulate the effect of an undeployed tip-mounted aerodynamic brake as shown\nin Appendix A. Note that the blade radius was not changed during post-processing so the\npressure tap locations are at the same radial location, but the reference to 30% represents 30% of\n5.029 m, not 4.943 m. Throughout this report, references to the blade span are made for the 5.029-\nm radius, not the 4.943-m radius.\n\n**Data Details**\n\nFile naming information can be found in the attached Word document \"Sequence V Filename Key\", copied from the Phase VI Test Report.", "distribution": [{"@type": "dcat:Distribution", "accessURL": "https://a2e.energy.gov/data/uae6/uae6.z21.00", "description": "Main dataset landing page with options to request/download", "format": "00", "mediaType": "application/octet-stream", "title": "uae6/uae6.z21.00"}], "identifier": "https://data.openei.org/submissions/4217", "issued": "2018-11-29T00:00:00Z", "keyword": ["a2e", "atmosphere to electrons", "wind", "weto", "eere", "uae6", "Unsteady Aerodynamics Experiment Phase VI NREL-NASA Ames Wind Tunnel Experiment", "UAE6", "Wind Tunnel Tests Data", "Sequence V", "Raw Data", "z21", "00"], "landingPage": "https://a2e.energy.gov/data/uae6/uae6.z21.00", "license": "https://creativecommons.org/licenses/by/4.0/", "modified": "2020-03-27T00:00:00Z", "programCode": ["019:010"], "projectNumber": "67025", "projectTitle": "Wind Data Hub", "publisher": {"@type": "org:Organization", "name": "Wind Energy Technologies Office (WETO)"}, "title": "UAE6 - Wind Tunnel Tests Data - UAE6 - Sequence V - Raw Data"}